| | Sector | abcRecreational Services | Tender Value | INR 2.11 Lakhs approx. | | Location | Kerala - India | Ref.No | 86705415 | | Closing Date | 20 - Aug - 2025 | | | | Annual Plan-Kuthanur GP -Pro No /- RENOVATION OF EYYANKADU ANGANWADI-Pro No /-General Civil Work ,2.0 ,Building Maintenance ,15.7.1Demolishing brick work manually / by mechanical means including stacking of serviceable material and disposal of unserviceable material within 50 metres lead as per direction of Engineer-in-Charge.In mud mortar ,15.23.1Dismantling tile work in floors and roofs laid in cement mortar including stacking material within 50 metres lead.For thickness of tiles 10 mm to 25 mm ,15.2.2Demolishing cement concrete manually / by mechanical means including disposal of material within 50 metres lead as per direction of Engineer - in-Charge.Nominal concrete 148 or leaner mix ( including equivalent design mix) ,2.8.1Earth work in excavation by mechanical means (Hydraulic excavator) /manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift up to 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m.All kinds of soil ,OD182311/2025-2026DRY RUBBLE MASONRY _ Dry rubble without concrete levelling course masonry
with good quality blasted rubble including packing to compactness to lines and levels
cost and conveyance of all materials labour charges etc. complete as per direction of
Departmental officers at site ,7.1.1Random rubble masonry with hard stone in foundation and plinth including levelling up with cement concrete 1612 (1 cement 6 coarse sand 12 graded stone aggregate 20 mm nominal size) up to plinth level withCement mortar 16 (1 cement 6 coarse sand) ,5.9.1Centering and shuttering including strutting, etc. and removal of form forFoundations, footings, bases of columns, etc for mass concrete ,5.1.2Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level1153 (1 cement 1.5 coarse sand 3 graded stone aggregate 20 mm nominal size derived from natural sources) ,50.6.1.5Solid block masonry using pre cast solid blocks ( Factory made) of size 30x20x20cm or nearest available size confirming to IS 2185 Part I of 1979 for super structure up to floor two level thickness 20cm and above in CM 16 ( 1 cement 6 coarse sand) etc complete ,10.25.2Item Shifted to Sub head 14 as item 14.73
Item Shifted to head 14 as item 14.74
Steel work welded in built up sections/framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required.In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works ,10.16.1Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.Hot finished welded type tubes ,12.50Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+0.05%), total coated thickness with zinc coating 120 grams per sqm as per IS 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling/self tapping screws of size (5.5x55mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required. ,5.9.3Centering and shuttering including strutting, etc. and removal of form forSuspended floors, roofs, landings, balconies and access platform ,5.22.6Steel reinforcement for R.C.C work including straightening, cutting, bending, placing in position and binding all complete upto plinth levelThermo - Mechanically Treated bars of grade Fe-500D or more ,5.3Reinforced cement concrete work in beams, suspended floors, roofs, having slope up to 15° landings, balconies, shelves, chajjas, lintels, bands, plain window sills, staircases and spiral stair cases up to floor five level excluding the cost of centering, shuttering, finishing and reinforcement, with11.53 (1 cement 1.5 coarse sand (Zone III) derived from natural sources 3 graded stone aggregate 20 mm nominal size derived from natural sources). ,13.1.112 mm cement plaster of mix14 ( 1 cement 4 fine sand) ,13.16.16 mm cement plaster of mix13 ( 1 cement 3 fine sand) ,11.37Providing and laying Ceramic glazed floor tiles of size 300x300 mm (thickness to be specified by the manufacturer) of 1st quality conforming to IS 15622 of appro |
|
|
If you are a new user, then please
register, it's Free and then fill the form below.
If you are registered with us, just fill the form below, we will get back to you
shortly.
|
All fileds marked with '*' are compulsary.
|
|
|
|